VTech VM5254 Guia De Inicio Rapido página 8

Night vision
Dim mode
Dim mode helps you save parent unit power. Your parent unit display will automatically
dim after 10 minutes of inactivity, when no keys are pressed or alerts are received from
the baby unit.
10 mins inactive
Press any button
The baby unit has infrared LEDs that allow
you to see your baby clearly at night or in
a dark room. When the baby unit detects
low light levels, the infrared LEDs switch on
automatically. The images from the baby
unit is then in black and white, and
appears on the screen.
Notes
• It is normal to see a short white glare on
your parent unit screen as the baby unit
adapts to the dark environment.
• When the infrared LEDs are on, it is normal
for the images to be in black and white.
Tip
• Depending on the surroundings and other
interfering factors, for example, lighting,
objects, colours and backgrounds, the
image quality may vary. Adjust the baby
unit angle or place the baby unit at a higher
location to prevent glare and a blurred
display.
14
Mount the baby unit on dry wall (optional)
Notes
NOTE NOTES
• Check for reception strength and cam-
era angle of the baby unit before drilling
the holes.
• The types of screws and anchors you
need depend on the composition of
the wall. You may need to purchase the
screws and anchors separately to mount
your baby units.
2. If you drill the holes into a stud, go
to step 3.
• If you drill the holes into an object
other than a stud, insert the wall
anchors into the holes. Tap gently
on the ends with a hammer until
the wall anchors are flush with the
wall.
3. Align the wall mount bracket and screws with the
holes in the wall as shown. Tighten the screw in the
middle hole first, so that the wall mount bracket
position is fixed. You can tighten the other screw in
the top hole.
4. Place the baby unit on the wall mount
bracket, and then slide it forward until it
locks into place. Connect the power adapt-
er to the baby unit and a power supply.
1. Place the wall mount
bracket on a wall
and then use a pen-
cil to mark two holes
in parallel. Remove
the wall mount
bracket and drill
two holes in the wall
(5.5mm drill bit).
15