TO ADJUST:
1.
Lift the fence Clamping Lever and remove the Fence.
2.
Slightly tighten or loosen one of the two
Set Screws (A) shown in Figure 13, using
a 3mm Hex Wrench (not supplied).
IMPORTANT: Very little movement of the set screws is
necessary to adjust the Fence.
3.
Place the Fence on the Guide Tube
and check the alignment again.
4.
Repeat Steps 1-3 until the Fence edge is
parallel to the Miter Gauge Slot.
SQUARING THE FENCE TO THE
TABLE
To reduce the risk of injury, turn unit off and disconnect it from power source before installing/removing
accessories, adjusting, or making repairs. An accidental start-up can cause injury.
1.
Lock the Fence in place on the Table.
2.
Using a T-Square (B) placed against the middle of
the fence, check to see if the Fence is perpendicular
to the table as shown in Figure 14.
TO ADJUST:
1.
To adjust, locate the two Nylon Set Screws (C)
on top of the Fence shown in Figure 15.
2.
Using a Flat-Head Screwdriver, rotate the Nylon Set
Screws to bring the Fence perpendicular to the Table.
3.
Re-check the alignment and continue to
adjust the Screws until the Fence edge
is perpendicular to the Table.
OPERATION AND ADJUSTMENTS
A
FIGURE 13
FIGURE 14
FIGURE 15
10
B
C