Descargar Imprimir esta página

Delta Machinery 36-T30 Manual De Instrucciones página 12

Ocultar thumbs Ver también para Machinery 36-T30:

Publicidad

Idiomas disponibles

Idiomas disponibles

For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers or call Delta Power
Equipment Customer Care at 1-800-223-7278.
To reduce the risk of injury, turn unit off and disconnect it from power source before installing/removing accessories, adjusting, or
making repairs. An accidental start-up can cause injury.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed
air. All plastic parts should be cleaned with a soft damp cloth.
NEVER use solvents to clean plastic parts. They could possibly
dissolve or otherwise damage the material.
MAINTENANCE REMINDERS
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
Specific areas which require regular maintenance include:
RIVING KNIFE CLAMP PLATE:
debris buildup. Blow out area regularly with compressed air.
NOTE: If the riving knife clamp can't move freely, have
the saw serviced by authorized DELTA
Corporation service center personnel.
LUBRICATION & RUST PROTECTION
Apply hardwood flooring paste wax to the machine table
occasionally or use a commercially available protective
product designed for this purpose. Follow the manufacturer's
instructions for use and safety.
FENCE LUBRICATION
1.
Apply Paste Wax to the Fence and the
Guide Tube sliding surfaces weekly.
2.
Occasionally apply Grease to the Cam Lock, and the
Cam Foot (A), shown in Figure 18, to prevent wear.
TROUBLESHOOTING
MAINTENANCE
Keep this area free of dust and
Power Equipment
®
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
For best performance use a shop vacuum or blower to keep saw
blade area, the dust collection system, the guarding system and
rails free of saw dust and other debris.
Keep the worm gears free of dust and debris
WORM GEARS:
buildup. Blow out area regularly with compressed air. Use a
lithium-based multipurpose grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET PERIODICALLY:
Debris can also be removed from the saw from below
NOTE:
the throat plate, inside the dust port.
To clean cast iron tables of rust, you will need the following
materials: a medium sized scouring pad, a can of spray
lubricant and a can of degreaser. Apply the spray lubricant and
polish the table surface with the scouring pad. Degrease the
table, then apply the protective product as described above.
12
A
FIGURE 18

Publicidad

loading

Este manual también es adecuado para:

Machinery 36-t50