Publicidad
Idiomas disponibles
Idiomas disponibles
SETTINGS ADJUSTMENT
DETECTION
RANGE
DELAY IN TIME
SECURITY TIME
COMFORT FLUSH
Adjusting the settings with the remote control
If necessary, the sensor settings can be adjusted as following:
Shut off the water supply. In order to adjust the sensor with the remote control,
hold the remote control straight in front of the sensor in a distance of about 6-8"
(15-20cm). Choose the function you want to adjust by pressing once on one of the
function buttons. After pressing once on a specific function button, a quick flashing
of the LED at the front of the sensor will occur. At this stage, you can change the
setting by pressing the (+) or the (-) buttons, every push will increase or decrease
one level. After finishing the adjustment, turn the water supply back on.
DETECTION RANGE: Only if necessary, use the remote control to
adjust the sensor range as follows:
Press the RANGE button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the one level and
– to reduce it every push will increase or decrease one level.
NOTE: Once you have changed the detection range with the remote control,
this distance will be remembered by the sensor, even if the power source is
disconnected.
8
DELAY OUT TIME
TEMPORARY OFF
FUNCTION
RESET
HYGIENE FLUSH
Publicidad
