Descargar Imprimir esta página

Monogram ZIC363 Manual Del Propietário página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

CONTROLS
CONTROL PANEL
The control panel shows the set temperature of the
fresh food, convertible and freezer compartments.
The actual temperature will vary from the set temperature
based on factors such as door opening, amount of food,
defrost cycling and room temperature.
NOTE: Frequent door openings or a door left open for
periods of time may increase the internal temperature of
Before changing the temperature, press the Zone Select
To change the temperature settings, press the (+) or
(-) pads to desired
Temperature Ranges
temperature set point.
Allow 24 hours for the
refrigerator to reach the
temperature you have
set.
-21°C
CHANGING DISPLAY TEMPERATURES FROM °F TO °C
To change between Fahrenheit and Celsius, press and hold the Zone Select and (-) pads on the control panel for 3 seconds.
TurboCool™
TurboCool™ rapidly cools the refrigerator to cool foods
faster. Use TurboCool™ when adding a large amount of
food to the refrigerator, when putting away foods after they
have been sitting out at room temperature, or when putting
away warm leftovers. It can also be used if the refrigerator
has been without power for an extended period.
Access TurboCool™ in the SmartHQ™ App to activate
the feature. The display will show tc. After 8 hours, or if
TurboFreeze™
SmartHQ™ App to activate the feature.
NIGHTTIME SNACK MODE
Use Nighttime Snack Mode to lower the level of the interior lights. Access Nighttime Snack mode in the SmartHQ™ App
to activate the feature.
10
Preset Settings: Allow 24 hours to reach these preset temperatures.
Low
High
34°F
42°F
Refrigerator
1°C
6°C
-6°F
+4°F
Freezer
-16°C
ON
FRIDGE
DOOR
ALARM
TOP
OFF
For the Convertible Drawer,
touch, only a single tap is necessary to switch between
Convertible Drawer Preset Zones:
Ice Cream 10°F (-12°C)
Meats 29°F (-2°C)
Drinks 33°F (1°C)
Snacks 37°F (3°C)
Produce 41°F (5°C)
To turn off the cooling system press and hold both (+)
and (-) pads for 3 seconds. Once complete, the display will
show COOOLING OFF.
To turn the cooling system on, press either (+) or (-) pad
and the display will show COOLING ON.
NOTE: Setting the controls to COOLING OFF stops
cooling, but does not shut off electrical power to the
refrigerator.
TurboCool™ is deactivated through the app, the refrigerator
will return to the original setting.
NOTE: The refrigerator temperature cannot be changed
refrigerator door during TurboCool™, the fans will continue
to run if they have cycled on.
49-1000709 Rev. 1

Publicidad

loading