Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS LIST
1
2
OPTIONAL
Corner Trim
RECOMMENDED TOOLS
1
Utility Knife
5
6
Flathead Screwdriver
Rubber Mallet
SHOWER
WALL
SHOWER BASE
3
Tongue & Groove Panel
OPTIONAL
Edge Trim
2
Locking Pliers
7
Circular Saw
BACKER
BOARD
STUD
NAILING
FLANGE
4
Beveled Edge Panel
3
Construction
Grade Adhesive
8
Hole Saw
NOTE:
SHOWER BASE INSTALLATION
When used in conjunction with a shower base that
has a nailing flange, the Jetcoat® Shower Wall System
is designed to be installed as shown in the drawing.
The nailing flange of the base should be attached
directly to the bare studs with backer board attached
to the studs above the nailing flange. The Jetcoat®
walls are installed on the backer board extending
down in front of the nailing flange and resting on the
base. Failure to install your base in this configuration
may cause problems installing the Jetcoat® walls.
- 2 -
5
Double-Sided
Construction Tape
4
Silicone
9
Measuring Tape
Publicidad
