Publicidad
Idiomas disponibles
Idiomas disponibles
2.5. Installation
2.5.1 Soldering iron
1.
Remove silicone protection from the soldering tip.
2.
Place the soldering iron in the soldering iron tray.
3.
Insert the 5-pin plug into the socket of the soldering station. Pay
attention to the markings on the plug and socket.
2.5.2 Hot air piston
Before using it for the first time, the tray for the hot air plunger must be
installed. The installation can be done both on the left and on the right.
1.
Remove 2 screws on the side of the station.
2.
Attach the shelf to the station with both screws.
3.
Place the hot air flask in the shelf.
NOTE: When the station is in operation, the hot air piston is automatically
cooled to a temperature of 100°C after it has been placed in the tray before
shutting off completely. Re-removing the piston switches from standby mode to
the working mode of the last set parameters.
2.5.3 Connect
Connect the station to the 3-pin socket on the back and a 230V socket via the
included power cable. Now the station can be switched on via the power switch.
2.6. Settings
2.6.1 Temperature settings
The "▲" and "▼" buttons on the left side can be used to
change the hot air temperature. The "▲" and "▼" buttons on
the right side can be used to change the soldering tip
temperature. The "▲" and "▼" buttons on the right side can be used to change
the soldering tip temperature.
5
USER MANUAL
Publicidad
