MOTION BLINDS CM-06 Manual Del Usuario página 3

Important Safety instructions
WARNING: To reduce the risk of severe injury or
death, it is important to follow these instructions
for personal safety. Save these instructions.
Read and follow all installation instructions.
This appliance can be used by children aged
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children should not play with the
appliance. Cleaning and user maintenance should
not be performed by children without supervision.
Do not allow children to play with fixed controls.
Keep remote controls away from children.
Frequently examine
imbalance and signs of wear or damage to
cables and springs. Do not use if repair or
adjustment is necessary.
This instruction manual is also available on the
website.
The drive must be disconnected from its power
source during cleaning, maintenance and when
replacing parts.
The A-weighted emission sound pressure level
of the drive is equal to or less than 70dB(A).
Indoor and household use only.
Disconnect the drive from the power supply
or switch off the automatic controls when
maintenance, such as window cleaning, is being
carried out in the vicinity.
When operating a biased switch, make sure that
other persons are kept away.
Do not operate when maintenance, such as
window cleaning, is being carried out in the
vicinity.
The tube motor must only be supplied with safety
extra low voltage corresponding to the marking
on the appliance.
The maximum operating temperature of motor
is +45°C. The maximum charging temperature of
battery pack is +45°C.
This appliance contains batteries that are non-
replaceable.
the installation for
Important Installation instructions
WARNING: Important safety instructions. Follow all
instructions, since incorrect installation can lead
to severe injury.
This motor can only be used with soft material
for driven parts.
Hazardous unprotected moving parts of the
drive must be installed higher than 2.5m above
the floor or any other level surface that could
provide access to it.
Install the actuating member of a manual
release at a height less than 1.8m.
The actuating member of a biased switch is to
be located within direct sight of the driven part
but away from moving parts. It is to be installed
at a minimum height of 1.5m and not accessible
to the public.
The mass and the dimension of the driven part
must be compatible with the rated torque and
rated operating time.
Fixed controls have to be clearly visible after
installation.
The driven part must be compatible with the
rated torque 6.0N.m and rated operating time
(12 min).
Minimum tube diameter: Ø35mm.
The drive is intended to be installed at a height
of at least 2.5m above the floor or any other
accessible level surface.
All-pole disconnection switches must be
incorporated in the fixed wiring in accordance
with the wiring rules.
The appliance must only be supplied at safety
extra low voltage corresponding to the marking
on the appliance.
Before installing the drive, remove any unnecessary
cords or components and disable any equipment
not needed for powered operation.
3