Thermador PROFESSIONAL PRO GRAND PRD36 Manual De Instalación página 11

Remove all tape and packaging before using the
appliance. Please, recycle the packaging
material, as all THERMADOR
packaging material is recyclable. Never allow
children to play with packaging material.
3. All ranges are held to the pallet by (4) bolts through a
wood block center (see Figure 5). The two front pallet
bolts are accessible only after removing the Door
Trim located beneath the doors.
• The Door Trim is removed by loosening the 2
screws attaching it to the range and sliding it up
and off the screws.
Loosen Screws
Wood Packing Blocks
Pallet Bolts
Figure 5: Door Trim, Packing Blocks, & Pallet Bolts
4. After removing the pallet bolts using (2) 1/2" (13mm)
wrenches (one to hold bolt at the bottom while the
other is loosening the nut at the top) and discarding the
wood packing block inserts, the range may be carefully
tilted back on the (2) casters (see Figure 24 on
page 25) and removed from the pallet. Use additional
help as required to remove from pallet.
• Due to the weight, a furniture dolly with soft wheels or
®
appliance
• After transporting the range by dolly close to its final
• Use the casters to assist with the installation near to its
an air lift should be used to move this unit. The weight
must be supported uniformly across the bottom (see
Figure 6).
location, the range can be tipped back and supported on
the rear casters while the dolly is carefully removed.
• "Step 5: Installing Anti-Tip Device", "Step 6: Gas
Requirements and Hookup", "Step 7: Electrical
Requirements, Connection & Grounding", and
"Step 8: Backguard Installation (optional)" must be
completed before the range is placed in its final
position.
final location. THE FLOOR UNDER THE LEGS
SHOULD BE PROTECTED BEFORE
UNIT INTO POSITION.
Figure 6: Furniture Dolly Positioning
PUSHING THE
Range must
be uniformly
supported by
braces
provided on
bottom of
range.
3
22 " (578mm)
/
4
English 9