Vision TC3 Manual Del Producto página 8

SIMPLE PROGRAMMING – WITHOUT PC
For controlling one device by IR only. Note: Epson projectors cannot be programmed this way.
1. Press and hold buttons 3 and 4. The LED will turn red and stay on.
2. Press and release button you want to assign code to.
3. Point original remote control at rear of module. It should be close and perpendicular. Shield
from ambient light.
4. Press and hold button on remote for 3 seconds. The green LED will flash to show it has
learned the code. If red LED flashes, try again.
5. The device will revert to normal mode once it has learnt a code. Repeat above to program
other buttons.
8