Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLE SHOOTING
1. If the blade does not spin, make sure the two blades are assembled correctly. The front side of the blades (where the ball
bearing is visible) should face outside. The backside of blades (where the ball bearing is covered) should face inside.
The two blades should face opposite directions.
2. If one blade is spinning while the other one is not, or if one blade is spinning faster than the other, pay attention to below:
a. Rotate the T-Bar so that the two blades are facing the direction of the wind, or
b. Wait until the wind is stronger. Wind speed and/or direction change may cause one blade to spin faster than the
other.
3. The two Blades (B & C) are designed to spin in opposite directions. If wind speed or direction change, they may spin in
the same direction. Wait until the wind is at a steady speed to experience proper spinning.
WARNINGS & CAUTIONS
1. This item is not a toy. DO NOT ALLOW CHILDREN TO CLIMB ON, HANG FROM, OR PLAY WITH THIS ITEM.
2. When the blades are spinning at a high speed, DO NOT TRY TO TOUCH BLADES AS IT MAY CAUSE INJURY.
3. Remove the T-Bar and Blade Assembly when the wind speed reaches 56.3 kilometers (35miles) per hour or greater.
CARE AND MAINTENANCE
To clean, use a soft cloth or sponge. To avoid damaging the finish, DO NOT USE ABRASIVE CLEANERS OR STEEL
WOOL
Publicidad
