Publicidad
Montageanleitung
DE
FR
Instructions de montage
IT
Istruzioni di montaggio
APPLICATION
- Installation must be carried out by a qualifi ed person.
- Mark the fastening points on the outside wall of the vehicle. When installing the awning
please make sure that the brackets are in correspondence with the sign "SUPPORT"
and with the arms fi xing points in the case box.
INSTALLATION
A1/A2 - Kit (page 14-15)
Look at the diagram to locate the position of the adapters. When installing the brackets,
make sure that they are aligned.
A3 - Full length adapter (page 16-17)
- Fastening with the furnished fastening material:
1) Place the profi le so that enough space is left for fastening the counter plates inside the
vehicle and mark the position of the four square holes.
2) Drill Ø6.5mm holes right through the roof.
3) Put silicone paste into the holes.
4) Put the gaskets in correspondence with the holes.
5) Install the adapter profi le with the provided bolts an counterplates. Drill Ø3mm holes
right through the small holes of the adapter in the vehicle wall. Fill the drilled holes up
with silicone paste and screw in the screws as shown. Attach the sideplates with the
Ø4.2x25mm screws.
6) Fasten the Fiamma awning to the adapter profi le.
7) Drill 3 small holes Ø5.2mm in the bottom of the box and fasten the awning with the
Ø5x12mm screws you will fi nd inside the Fiamma installation kit.
OPTIONAL (page 18)
- Fastening with SIKA 252 white glue. Put the glue on the full length of the adapter profi le
as shown. Position the profi le on the vehicle.
10
EN
ES
Fiammastore
Installation instructions
Instrucciones de montaje
Publicidad
