Panasonic EY7880 Manual De Instrucciones página 8

While the battery pack release button
is held up, ( ) move the battery pack
laterally and pull out the pack. (
Battery
holder
-For installation-
To attach the battery pack, line up the
alignment marks on the body of the
tool and the battery pack, (
insert the battery pack. (
• After you hear the battery pack
clicks when inserting it, keep in-
serting it firmly until the lever locks
it to click once more.
NOTE:
The overheat warning lamp and
the battery low warning lamp will
flash when the battery pack is not
inserted firmly.
. OPERATION
[Main Body]
Forward/Reverse lever
Forward
Be sure to set the switch in the cent-
er to lock it after use.
Operate the Forward/Reverse lever
after the motor rotation is completely
stopped.
Hammering/drilling switching
lever/Speed/Blow Mode selec­
)
tion lever
Release
lever
Position
of switch-
) and
ing lever
)
(Rotation
with ham-
mering)
(Rotation only)
Variable speed control trigger
Reverse
- 8 -
1. There are four modes available with
the combination of Hammering/ drill-
ing switching lever and Speed/Blow
Mode selection lever.
Select the suitable mode for appli-
cation.
2. Operate the mode change af-
ter the motor rotation is completely
stopped.
Speed/Blow Mode
selection lever
Hard blow hammer- This mode has hard
ing mode blow
which is suitable for
concrete drilling.
Soft blow hammer- This mode is suitable
ing mode for concrete drilling
with smaller diameter
drill, or for drilling into
soft base material.
High speed drilling mode This mode is suitable
for metal drilling with
high speed rotation.
Slow speed drilling mode This mode is suit-
able for wood drill
with high torque.
To set the center of a hole, pull the trig-
ger slightly to start the drill rotation
slowly.
Recommended
application
hammering
Concrete drill
Small diameter
concrete drill
Metal drill
Metal hole saw
Wood drill