Descargar Imprimir esta página

Panasonic EY7880 Manual De Instrucciones página 9

Ocultar thumbs Ver también para EY7880:

Publicidad

Idiomas disponibles

Idiomas disponibles

Support handle
Place the support handle at your favorite
position and tighten the handle securely.
Loosen
Tighten
Depth gauge
Loosen the support handle and adjust
the depth gauge at your favorite depth.
After adjusting, tighten the support
handle and fix depth gauge.
Depth gauge
Depth of drilling
Installing the Shoulder Strap
CAUTION:
• Install the shoulder strap firmly to
the main unit of the tool and check
the length of the strap before use.
• Check the condition of the strap
and do not use if it is cut or torn etc.
There is a risk of injury or damage
if used while improperly installed.
• Please wear the shoulder strap se-
curely on the shoulder.
There is a risk of injury or damage
if it is accidentally dropped.
1. Pass the strap through the strap
holders.
2. Pass the strap through the buckles
and adjust the length.
Shoulder pad
Follow the instructions below in order
to avoid injury.
• The shoulder strap can be adjusted
according to the individual.
• Adjust the shoulder pad to the
shoulder.
• Pull the shoulder strap to make
sure it is firmly attached to the main
unit of the tool.
Control panel
(1)
(1) Battery low warning lamp
Off (normal
operation)
Excessive (complete) discharging of
Li-ion batteries shortens their service
life dramatically. The rotary hammer
includes a battery protection feature
designed to prevent excessive
discharging of the battery pack.
• The battery protection feature ac-
tivates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
• If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
(2) Overheat warning lamp
Off (normal
Flashing: Overheat
operation)
Indicates operation has
been halted due to motor
or battery overheating.
The overheating protection feature
halts driver operation to protect the
motor and battery pack in the event
of overheating. The overheat warning
lamp on the control panel flashes
when this feature is active.
- 9 -
()
(2)
Flashing (No charge)
Battery protection
feature active

Publicidad

loading