Thomasville Messina 523122 Instrucciones De Armado página 3

Page 3 of 4
Assembly Instructions
Note: The carton contains the hardware & parts for four dining chairs. The seat frames (A), left & right arms
(B & C), front spring rails (D), and back rails (E) are labeled 1, 2, 3, & 4. When assembling, use like labeled parts
for each chair. For example all parts labeled (1) should be used on the same chair.
1. On a flat and level surface; assemble the left arm (B-1), right arm (C-1), and back rail (E-1) as indicated in Figure 1 using the
screws (K), washers (L), and hex key (P). Do NOT completely tighten the screws or install the PVC screw covers (N) at this
time since some minor adjustment may be necessary in Step 2.
Repeat Step 1 for the remaining three chairs using the parts labeled 2, 3, & 4.
Figure 2
2. Insert the front spring rail (D-1) into the brackets on the inside of the arms (B-1 & C-1) and loosely attach the spring rail to the
arms using four screws (F) and flat washers (L). See Figure 3. Do NOT completely tighten any of the screws until all four
have been inserted. Once all four screws have been inserted, make sure all four legs are evenly contacting the surface on
which it is sitting and then securely tighten the four screws using the hex wrench-1 (Q). Then, with the hex key (P), finish
tightening the four screws from Step 1. Be careful not to over tighten any of the screws. After all of the screws have been
securely tightened, install four PVC screw covers (N) as shown in Figure 2.
Repeat Step 2 for the other three chairs using the spring rails D-2, D-3, & D-4 in the appropriate chair frames.
Note: Make sure the front spring rails (D) are inserted as indicated
in Figure 3. Insert the end labeled "a" into the arm bracket labeled
"a" and the end labeled "b" into the arm bracket labeled "b".
TM
Messina Concealed Motion Dining Chair
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
Model #: 523122
Model #: 523127
Figure 3