Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING THE BAR AND CHAIN
WARNING:
is removed. Failure to heed this warning could result in serious personal injury.
WARNING:
components are sharp and may contain burrs.
WARNING:
chain is very sharp; always wear protective gloves when performing maintenance to the
chain.
NOTICE:
When replacing the guide bar and chain, always use the specified bar and
chain combination listed in the later section: "Recommended Bar and Chain for this
Chain Saw".
Disassemble the Worn Bar and Chain
1. Remove the battery, allow the saw
to cool and tighten the oil tank cap.
2. Position the chain saw on its side on
a firm,flat surface, so that the side
cover is facing upwards (Fig. 29).
3. Wear gloves. Remove the side cover
by turning the side cover knob
counterclockwise (Fig. 29). Clean
the side cover with a dry cloth.
NOTICE:
This is a good time to inspect the drive sprocket for excessive wear or
damage.
Assemble The New Bar And Chain
Follow the instructions step 4 to step 10 in the ASSEMBLING/REPLACING THE BAR
AND CHAIN section in this manual.
Adjust The Chain Tension
Follow the instructions in the ADJUSTING THE CHAIN TENSION section in this manual.
38
56V LITHIUM-ION CORDLESS CHAIN SAW
Before performing any maintenance, make sure that the battery pack
Always wear gloves when handling the bar and chain; these
Never touch or adjust the chain while the motor is running. The saw
29
Side Cover
Chain Tensioning Knob
Side Cover Knob
Publicidad
