4K5 PDS 5 Manual página 11

– Repairs must only be carried out by authorised
dealers.
– Incorrect assembly can result in fire or the risk of a
fatal electric shock.
– Do not expose the device and its plug to any mechan-
ical stress, extreme temperatures, humidity, or sig-
nificant vibration.
– The device if one or a number of its functions fails, or
if the housing or connections are damaged.
– The battery may be charged only with the enclosed
USB charging cable on a standard commercial USB
power supply unit (5V/>= 1000mA). Any other use
may cause injury or fire.
– Damage to or incorrect use of the battery pack can
cause vapours which can irritate the airways. Inhale
fresh air and contact a doctor if any symptoms occur.
– The battery pack is supplied partially charged.
– To ensure the battery pack is fully charged, charge
the battery pack fully before its first use using the
recommended charger.
– The charging process can be started or ended at any
time without cutting the useful life short.
– Charging in moderate temperatures increases the
useful life of the battery pack.
– A significantly reduced operating time after charging
indicates that the battery pack is spent and must be
replaced.
– Observe disposal instructions.
– Use only the original accessories.
– If incorrect accessories are used, the guarantee will
become void.
– The battery charging status display changes to green
when charging is complete.
– Remove the charging cable after charging and
disconnect the power pack from the mains.
– Risk of damage! If the screw head slips, sensitive
materials can be damaged.
– Ensure connecting cables are placed such that
they avoid being trodden on, clamped or put under
tension.
– Take particular care to protect the plug connections
to the device and sockets.
– The device is intended for use on a secure, flat
surface.
– Risk of overheating! The device can overheat when
operated for a long time under full load. Schedule
working breaks for cooling.
– The device is not suitable for unsupervised use.
– The device complies with the provisions and limit
values for safety and electromagnetic compati-
bility in accordance with the Machines Directive
11
EN