Publicidad
Idiomas disponibles
Idiomas disponibles
Features and Indications
Cycle Selector
Use Cycle Selector to customize cleaning mode to "Floor only":
1. Press ON to activate until the LED lights up.
2. Press ON again for 3-6 seconds until the purple LED blinks 3 times.
Place the robot in the pool, and within 30 sec, it will start working.
After each cleaning cycle, the robot will return to default
"Floor and Walls" mode.
Eco Mode
Use Eco Mode to keep your pool floor clean for a week on one charge.
The robot will automaticly clean the pool floor for up to 30 min,
3 times a week, with 48 hours between cleaning cycles.
1. Press ON to activate until LED lights up.
2. Press ON again for 6 seconds until green LED blinks. Place the
robot in the pool, and within 30 sec, it will start working.
Temperature Warning
In case of temperature warning notification, place and charge the
pool cleaner in a protected and shaded area, at a temperature
range of 43°F - 95°F / 6°C - 35°C.
Error
In case of error notification, please refer to User Manual.
Charging Recommendations
•
When the battery is low and all indicators are off - the cleaner is on standby mode.
Connect to charger to wake it up.
•
Always Charge the pool cleaner in a protected and shaded area at a temperature range of
43°F - 95°F / 6°C - 35°C, until you see 3 green bars in the battery indicator panel (up to 6 hours).
•
The charger is waterproof, the robot can be charged when wet. However, do not put the
charger in the water.
Off-Season Storage
Before off-season storage - Charge the battery at least 50%
(2 green bars in the battery indicator panel).
Recommended storage temperature range: 14°F - 104°F / -10°C - 40°C.
After off-season storage, charge the robot to its fullest.
|
- LIBERTY 300
- LIBERTY 300
EN - LIBERTY Quick User Guide | 2
Publicidad
