Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The following symbols are found on your charger:
#
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
$
a regular mains plug.
+
The charger is intended for indoor use only.
Read the instruction manual before use.
Charge only at ambient temperatures between
10 °C and 40 °C.
#
Electrical safety
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
Overview
1. On/off switch
2. Lock-off button
3. Main handle
4. Trimmer head
5. Blade
6. Blade sheath
7. Battery
Fig. A
8. Charger
9. Charging indicator
10. End of charge indicator
Assembly
Warning! To prevent accidental operation, ensure that the
battery is removed and that the blade sheath is in place on the
blades before performing the following operations. Failure to
do this could result in serious personal injury.
8
Fitting and removing the trimmer head (fig. C)
Fitting the trimmer head
Align the groove on the outside of the coupling end of the
u
handle (3) with the tongue on the inside of the coupling
end of the trimmer head (4).
Push the trimmer head (4) onto the handle (3).
u
Slide the collar (12) down and rotate it clockwise until it is
u
fully tightened.
Warning! Periodically check the connections to ensure that
they are tightened securely. The collar is correctly secured if
there are no orange threads visible.
Removing the trimmer head
Rest the handle (3) on the ground, loosen the collar (12)
u
and take off the trimmer head (4).
Adjusting the trimmer head angle (fig. D)
The trimmer head pivots 180° and can be locked into
5 positions within that range.
Warning! To avoid being pinched, wear gloves and hold the
unit as shown.
Rest the handle (3) on the ground, slide the collar (13)
u
down and move the trimmer head (4) as required.
Make sure the trimmer head clicks into place.
Fitting and removing the battery (fig. B)
To fit the battery (7), line it up with the receptacle on the
u
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (11) while
u
at the same time pulling the battery out of the receptacle.
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before. When charging the battery for the first
time, or after prolonged storage, it will only accept an 80%
charge. After several charge and discharge cycles, the battery
will attain full capacity. The battery may become warm while
charging; this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
To charge the battery (7), remove it from the tool and
u
insert it into the charger (8). The battery will only fit into
the charger in one way.
Publicidad
