Publicidad
Idiomas disponibles
Idiomas disponibles
Obligation signs
en
Wear eye
Wear a hard
protection
Wear
breathing
protection
Symbols
Read the
Return waste
operating
material for
instructions
recycling.
before use
Chiseling
Chisel
position
adjustment
2 Description
2.1 Use of the product as directed
The power tool is an electrically-powered combihammer with pneumatic hammering mechanism. The ATC (Active
Torque Control) function of the TE 60-ATC / TE 60T‑ATC provides greater operating comfort while drilling.
The tool is designed for drilling in concrete, masonry, metal and wood and can also be used for chiseling.
The power tool is equipped with electronic overload protection. If the power tool is overloaded for a continuous period,
motor speed will be reduced automatically and, if necessary, the motor may be stopped completely. When the control
switch is released and then pressed again, the motor immediately regains full power. When restarting, care should
thus be taken to ensure that the power tool is held securely with both hands.
Under certain conditions, the power tool is suitable for use for mixing (see "Tools, accessories" and "Operation").
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be used only in a dry environment.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there is a risk
of fire or explosion.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Modification of the power tool or tampering with its parts is not permissible.
2
Wear ear
hat
protection
Drilling
without
hammering
Volts
Alternating
current
Wear
protective
gloves
Revolutions
per minute
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Hammer
drilling
Type:
Generation: 02
Serial no.:
Amps
Hertz
Rated speed
under no
load
Diameter
Equipped
with theft
protection
system
Revolutions
per minute
Lock symbol
Publicidad
