Milwaukee M18 FUEL 0888-20 Manual Del Operador página 6

Installing the Hose Hooks
1. Slide the four hose hooks onto the mounting
brackets.
2. Wrap hose around head and on top of hose hooks
for storage.
Installing/Changing the Fleece Dust Bag
CAUTION
bag volume and do not overfill.
For increased filter life and ease of cleanup, use a
fleece dust bag to collect fine dust particles
1. WARNING! Unplug and remove batteries to avoid
starting the tool.
2. To install, release the tank latches and remove
the motor housing.
3. Place the cardboard dust bag inlet around the
tank inlet with the cardboard tab facing upwards.
4. Slide the cardboard dust bag inlet over the ridge
of the tank inlet to secure.
5. Spread out the dust bag in the tank. Replace the
motor housing and secure latches.
6. To remove, release the tank latches and remove
motor housing.
7. Slide the dust bag away from the tank inlet and
then up and out to remove from the tank.
8. Pull the cardboard tab until the dust bag inlet
is closed. Dust bag is now sealed and can be
properly disposed.
Replace fleece dust bag once the bag is at full ca-
pacity, suction decreases or dust bag is damaged.
Installing the Hose and Accessories
1. Fit the hose into the inlet and twist to secure.
To avoid spilled debris
when picking up heavy or
sharp materials monitor
2. Press the button and insert the appropriate tool
or accessory onto the hose until the latch clicks
to secure.
Removing/Installing the Filters
Filters can become clogged during heavy use. To
maintain the efficiency of the dust extractor, empty
the tank, change the filter bag, and clean both of the
filters periodically. MILWAUKEE suggests cleaning
the filters after 200 holes (at 5/8" diameter, 4" deep)
or an equivalent amount of produced dust.
To remove the filters:
1. Turn off the dust extractor.
2. WARNING! Unplug and remove batteries to avoid
starting the tool.
3. Unlatch and open the filter compartment.
4. Pull the filters away from the extractor.
5. To clean the filter, while holding over a trash can,
tap gently to dislodge any remaining dust.
6. Water may be used to clean the filter. If cleaning
filters with water, let filters completely dry before
using with the extractor.
7. Replace filters if damaged or airflow decreases.
See "Specifications" for replacement part number.
8. To install the filters, reverse the procedure.
6
Filters