Power Dynamics PD810R Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature. For safety instructions, please refer
to the instruction manual of 179.002, the PD810 main item.
RECEIVER
1. Earphone jack
3.5mm earphone jack.
2. Balance
Left/right balance adjustment knob.
3. Antenna
4. LED indicator
LED flashes in red color when battery level is low.
LED will light up when signal is received.
5. LCD display
6. On/off
7. Up
8. Down
9. Set
10. Battery compartment (2xAA batteries)
Insert two AA-type batteries to power the receiver. Open the receiver's front
cover and insert the batteries as instructed in the battery compartment. The
display shows the power level of the batteries: When the battery indicator
flashes, the batteries are empty and the receiver will automatically switch off
shortly after. If the receiver is not used for a long period (approx. 1-2 weeks),
remove the batteries to protect the device from possible leakage.
RECEIVER DISPLAY
1. Reception
Shows reception quality.
2. Mode
Indicates whether stereo- or mono mode is being used.
3. Battery
Indicates battery level.
4. Group
Shows frequency group.
5. Channel
Shows channel.
6. Frequency
Shows frequency.
RECEIVER FUNCTION
Group and channel selection
Press SET, "GROUP" will flash. Press UP or DOWN to select the desired frequency group.
Press SET again, "CHANNEL" will flash. Press UP or DOWN to select the desired channel.
Mode selection
Press and hold SET, until "STEREO" will flash. Press UP or DOWN to select "STEREO" or "MONO", press SET to confirm.
3