PICO PicoConnect 900 Guia Del Usuario página 4

PicoConnect 900 Series Probes
WARNING
Signals exceeding the voltage limits in the table below are defined as "hazardous
live" by EN 61010. To prevent electric shock, take all necessary safety precautions
when working on equipment where hazardous live voltages may be present.
±60 V DC
WARNING
To prevent a safety hazard or equipment damage, do not probe circuitry,
interconnect or systems where an interruption of function, temporary or
permanent, could lead to hazard or harm. When probing data lines, consider in
particular the possible impact of temporary or prolonged data corruption. Probe
only under offline conditions.
CAUTION
To prevent measurement error or damage to the probe or connected equipment,
do not attempt to measure voltages outside the specified maximum voltages
marked on the product and in the table below. Also ensure that the test node is
capable of driving the additional load impedance of the probe without damage
to the device under test. For AC-coupled probes, this may include the charging
of the coupling capacitor (6.8 nF) to a DC bias condition through the probe input
impedance. See the Getting Started section.
RF, microwave and pulse probes
911
912
913
914
915
916
Gigabit probes
921
922
923
924
925
926
* For applied voltage above 42.4 V pk, pulse or burst width must not exceed
500 ns and mark-space must remain below 2%.
2
Signal voltage limits of EN 61010-031:2015
AC 14 V AC RMS
20:1
DC
AC 10 V AC RMS
10:1
DC
AC
5:1
DC
AC
20:1
DC
AC
10:1
DC
AC
5:1
DC
Copyright © 2017 Pico Technology Ltd. All rights reserved.
30 V AC RMS
50 V DC
14 V RMS
50 V DC
10 V RMS
8 V AC RMS 50 V DC
8 V RMS
7 V AC RMS 50 V DC
7 V RMS
5 V AC RMS 50 V DC
5 V RMS
5 V AC RMS 50 V DC
5 V RMS
±42.4 V pk max.
N.A.
150 V pk*
N.A.
N.A.
N.A.
25 V pk
N.A.
N.A.
User's Guide
960 Ω
440 Ω
230 Ω
515 Ω
250 Ω
220 Ω
DO274-4