Inglesina FAST Instrucciones De Uso página 13

r
u
LIST OF COMPONENTS
fig. 01
A Arms
r
B Clamps
g
C Support Arms
s
D Front Safety Strap
e
E Waist Belt
A
F Central Buckle
G Crotch Strap
p
H Lining
I Locking Pins
J Backrest pipe
K Lower Lateral Arms Cover
L Seat Pad
.
Before assembling, confirm that the hook-on chair and all its components have
not been damaged during transport or handling. If any damage exists, no matter
e
how slight, DO NOT USE THE CHAIR.
Contact Inglesina for any necessary replacement parts.
f
ASSEMBLY OF THE SUPPORT ARMS
fig. 02 The Support Arms (C) are delivered disassembled.
fig. 03 Place the plastic rings of the front safety strap (D) over the support arms (C). Slide
the support arms (C) into the frame of the Fast Seat.
fig. 04 The spring loaded locking pins (I) should "click" through the corresponding holes
in order to lock the support arms (C) in place.
WARNING! After having locked the support arms (C), always make sure that the locking
pins (I) are properly engaged by pulling at the same time the backrest (J) and each arm
(A).
Zip up the lower lateral arm covers (K) ONLY when the support arms (C) have been put
inside them.
POSITIONING CHAIR
fig. 05 Place the hook-on chair close to the table and slide the arms (A) along the top of
the table. Push the hook-on chair all the way forward to the edge of the table. The entire
bottom surface of the arms (A) must be in full contact with the top of the table. Confirm
the support arms (C) are properly in place under the table.
fig. 06 Screw the clamps (B) by rotating them counterclockwise until reaching the bottom
of the table. Tighten the clamps (B) at least three (3) full turns after the clamp (B) first
contacts the bottom of the table.
fig. 07 Zip the lower lateral arms cover (K) over the support arms (C), covering the
support arms (C) and clamps (B).
fig. 08 WARNING! Confirm that the hook-on chair is securely anchored to the
table by trying to pull it away from the table and downwards. Do not place a
child in the hook-on chair if chair moves at all during this test. Failure to securely
anchor the hook-on chair can result in an accident, personal injury or death.
fig. 09 WARNING! Never attach the hook-on chair to table tops with beveled,
angled or other decorative profiles more than 3.5 cm (35 mm or 1.3"), even if the
clamps (B) fully contact the underside of the table. There is a risk the hook-on
chair will detach from the table, resulting in an accident, personal injury or death.
fig. 10 WARNING! Never attach the hook-on chair to a table with profiles that do
not ensure full contact between the entire bottom surface of the arms (A) and the
INSTRUCTIONS
13