Publicidad
Idiomas disponibles
Idiomas disponibles
Product
Dimensions
_H
A
P
A.
1.09 m (43")
I.
Power supply cord
B.
970 mm (38%")
J.
Drain hose connector
C.
890 mm (35")
K.
Label
D.
38 mm (11/2 '')
L.
685 mm (27")
E.
705 mm (27%")
M.
133 mm (51/4 '')
R
650 mm (251/2 '')
N.
25 mm (1 ")
G.
Water inlets
O.
Water level switch and shaft
H.
180 mm (7")
R
127 mm (5")
Standpipe
Drain System
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
than 64 L (17 gal.) per minute.
The top of the standpipe must be at least 990 mm (39") high
and no higher than 1.83 m (72") from the bottom of the washer.
Electric Shock Hazard
Electrically earth this appliance.
Do not use an extension
cord or an electrical portable
outlet
device,
Failure to follow
these instructions can result in death,
fire, or electric shock,
[] A 220-240 volt, 50 Hz., AC only, 10-amp, fused electric
supply is required. A time-delay fuse or circuit breaker
is recommended.
It is recommended
that a separate circuit
serving only this appliance be provided.
[] This washer is equipped with a power supply cord having
an earthing plug. The plug should be accessible for
disconnection
from the supply.
[] If the supply cord is damaged,
it must be replaced by the
manufacturer,
its service agent, or similarly qualified persons
in order to avoid a hazard.
Using the universal
cord
included
with this
washer:
This washer is equipped with a universal cord with
interchangeable
mains plugs.
1. Select the appropriate
mains plug assembly from those
supplied and attach it to the mains cord connector.
2. Snap the 2 halves of the cord lock together over the
connector to retain it in position.
Publicidad
