Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRONIC CONTROLS SETUP
BASIC
OPERATION
OF COMMERCIAL
WASHER
[] For additional information, see www.MaytagCommercialLaundry.com.
[] This tech sheet is not valid for models prior to series MAT14.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
IM PORTANT
Electrostatic
Discharge (ESD)
Sensitive Electronics
ESD problems are present everywhere. ESD may damage
or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is finished,
but failure may occur at a later date due to ESD stress.
[] Use an anti-static
wrist strap. Connect wrist strap
to green ground connection
point or unpainted metal
in the appliance
-OR-
Touch your finger repeatedly to a green ground connection
point or unpainted metal in the appliance.
[] Before removing the part from its package, touch the
antistatic bag to a green ground connection point or
unpainted metal in the appliance.
[] Avoid touching electronic parts or terminal contacts;
handle electronic control assembly by edges only.
[] When repackaging
failed electronic control assembly
in antistatic
bag, observe above instructions.
GENERAL USER INFORMATION
Blank display
This condition indicates the appliance is inoperative. Enter
set-up mode to view diagnostic code.
"0 Minutes" showing
in display
This condition indicates the appliance cannot be operated.
Coins dropped or debit inputs during this condition will be
stored in escrow but cannot be used until normal operation is
restored by opening and closing the door. If a door switch fails,
it must be replaced before normal operation can be restored.
Cold Start (initial first use)
Washer is programmed
at the factory as follows:
[] 11-minute wash period
[] 1 rinse and 2 minutes of rinse agitation
[] $1.75 wash price (PD Models).
[] $0.00 wash price (PR Models).
Warm Start (after power failure)
After a delay of up to 8 seconds, the washer is restored to the
state that existed at time of the power failure.
Free Cycles
This is established by setting the cycle price to zero. When this
happens, "SELECT CYCLE" will appear rather than a cycle price.
Debit Card Ready
This washer is debit card "cable" ready. It will accept a variety
of debit card systems, but does NOT come with a debit card
reader. Refer to the debit card reader manufacturer
for proper
washer set-up. In models converted to a Generation
1 debit
card system, debit pulses represent the equivalent of one coin
(coin 1).
Display
After the washer has been installed and plugged in, the display
will show "0 MINUTES." Once the washer has been plugged in
and the washer door opened and closed, the display will show
the price. In washers set for free cycles, the display will flash
"SELECT CYCLE."
WHITES
COLORS
SRIGHTS
PERM.
DEUCATES
SMALL
PRESS
AND KNITS
LOAD
WHITES
COLORS
SRIGHTS
PERM.
DELICATES
SMALL
PRESS
AND KNITS
LOAD
WHITES
COLORS
8RIGHTS
PERM.
DELICATES
SMALL
PRESS
AND KNITS
LOAD
Publicidad
