Publicidad
Idiomas disponibles
Idiomas disponibles
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer indicator stays
lit. At the preset time, the air conditioner goes into standby.
To cancel the timer program, press the timer button (C6) twice.
The timer indicator (C8) will go off.
How to program delayed start up
•
Plug in the appliance and set to stand-by.
•
Press the timer button (C6): the timer indicator (C8) and
hours light up.
•
Set with the buttons
hours after which you want the appliance to start to oper-
ate.
•
The appliance will start to operate in the same operating
mode that was previously set.
Start up can be programmed at any time within the next 24
hours that follow. A few seconds after the timer is set, the setting
is acquired. The timer indicator stays lit and the display returns
to standby. To cancel the timer program, press the timer button
(C6) twice. The timer indicator (C8) will go off.
OPERATION USING THE REMOTE CONTROL
•
Aim the remote control at the receiver (A12) on the air con-
ditioner. The maximum distance between the remote con-
trol and the appliance is 23ft/ 7 metres (with no obstacles
between the remote and the receiver).
•
The remote control should be handled with extreme care,
without dropping it or exposing it to direct sunlight and
keeping it away from heat sources.
OPERATING FROM THE REMOTE CONTROL
INSERTING OR REPLACING THE BATTERIES
•
Remove the cover on the rear of the remote control;
•
Insert or replace the batteries with two new LR03 "AAA"
1.5V batteries, inserting them correctly (see the directions
inside the battery compartment) (see figure 7);
•
Replace the cover.
(C3) or
(C4) the number of
7m/23ft
Please note: If the remote control unit is replaced or discarded,
the batteries must be removed and disposed of in accordance
with current legislation as they are harmful to the environment.
Do not mix old and new batteries. Do not mix alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries. Do
not dispose of batteries in fire. Batteries may explode or leak.
If the remote control is not be used for a considerable length of
time, remove the batteries.
DESCRIPTION OF THE REMOTE CONTROL
D1. ON/STANDBY button
D2. MODE button
D3. Fan speed selection button
D4. Increase button
D5. Decrease button
D6. Timer button
D7. ARCTIC WHISPER button
D8. ECO REAL FEEL button
D
C11
C15
D1
C8
D7
C10
D5
C14
D8
TURNING THE APPLIANCE ON/OFF USING THE
C3
REMOTE CONTROL
•
Plug into the outlet.
C2
•
Press the ON/STAND-BY button
the air conditioner starts operating in the same mode as
10
7
C5
C6
C7
D2
C9
D3
C12
D4
D6
C13
C4
C1
(D1). When turned on,
Publicidad
