Adler europe AD 7863 Manual De Uso página 8

lay the handle flat before gently pushing the tank (3) back to its previous position inside the housing.
5. From time to time the water tank (6) needs to clean it inside. To open the water tank (3), adjust the position of water tank's handle
to shape of holes in two plastic parts the handle is assembled to and expand both edges of the handle gently to disassemble the
handle completely away. Now you can open the water tank's lid and clean the water tank by water with dish soap and soft cloth. Do
not dismantle or lift the floater (6) from the water tank (3). Look at picture
Buzzer
It sounds for 20 seconds when the water tank (3) is taken out during operation.
Cleaning and Maintenance
1. Turn off the device and disconnect the power plug before starting any cleaning or other routine maintenance.
2. To avoid the risk of electric shock, never sprinkle or spill water on the dehumidifier when cleaning.
3. Turn off the device and empty the water out of the water tank before moving the device. Be sure to hold the handle while moving.
4. Wipe up the housing of device with wet and soft cloth.
5. Don't dismantle the floater (6) from the water tank (3).
6. Prior to planned continuous operation for a long duration, periodical checking is required especially for the mesh air filter (8),
activated carbon filter (11) and the drain pipe (13), or the like.
7. To clean or replace the filters:
- disconnect the plug and take out the water tank (3)
- remove the filter housing (9) as shown in figure 5
- remove the mesh air filter (8) from the housing and gently remove the activated carbon filter (11)
- pull out HEPA filter (7) from device
- every two weeks, clean all three filters with a vacuum cleaner or lightly pat them to shake them out. Dehumidification performance
may decrease if the filters are clogged with dirt
- put the filters back and assemble the filter housing (9) again.
If filters are fouled seriously, wash in water including neutral detergent, rinse well with water and leave until dry.
8.Don't clean the device with gasoline, thinner or liquid detergent.
9. Before longer storage: bundle the power cord, empty water tank and wipe it by soft cloth, clean and dry all filters. Stand the device
upright position to avoid malfunction or abnormal sound in future, avoid the exposure to the direct sunlight.
Trouble – shooting : check with below list before contact the seller:
1.Problem: no operation
Checking point 1: see if the power plug is disconnected.
Solution 1: insert the plug into an electric outlet fully and securely
Checking point 2: see if the water tank is full of water
Solution 2: Empty the water out of the tank
Checking point 3: see if the water tank is not set properly in position
Solution 3: Set the tank to the device properly in position
Checking point 4: see if the top lid made from black plastic of air outlet is closed
Solution 4: open top lid
2. Problem: dehumidifier capacity is small
Checking point 1: see if the filters are dirty
Solution 1: Clean the filters as specified in chapter Cleaning and Maintenance in point 7
Checking point 2: see if the air openings are blocked up
Solution 2: remove obstacles from the air openings
Checking point 3: see if the dehumidifier is in air circulation mode
Solution 3: Change the operation mode to the dehumidifying mode
3. Problem: loud sound while operating
Checking point 1: check if the device is installed correctly
Solution 1: Install the device on a level and stable floor
4. Problem: washed cloths are not dried
Checking point 1: see if washed clothes are not exposed to the air from the device
Solution 1: Try to expose the washed clothes to the air flow
Checking point 2: see if the room temperature is too low
Solution 2: Washed clothes are hard to be dried under low temperature conditions
The device works properly when the following phenomenon occurs:
1.Phenomenon description: Operation stops occasionally
Reason of phenomenon: The device is defrosting
2.Phenomenon description: Dehumidified volume is small
8