Taurus ICE BRISE SILENCE Instrucciones De Uso página 7

EN English (Original instructions)
STAND FAN
ICE BRISE SILENCE
DESCRIPTION
A Front grill
B Fixing belt
C Security screw
D Propeller nut
E Propeller
F Grill nut
G Rear grill
H Motor shaft
I Motor housing
J Fan head
K Control panel
L Upper lock nut
M Supply cord
N Top tube
O Lower lock nut
P Bottom tube
Q Base
R Base's screw washer
S Base's screw
T Remote control
Control panel (K)
1 Swing button
2 Speed selection button
3 On/Off button
4 Display
Remote control (T)
a On/Off button
b Timer button
c Increase Speed/Time button
d Decrease Speed/Time button
e Swing button
f Low wind mode – Speed 3
g Medium wind mode – Speed 15
h High wind mode – Speed 24
USE AND CARE
• Fully extend the appliance's supply cord before each use.
• Do not use the appliance if the on/off button does not
work.
• Do not use the appliance if the speed selection buttons
do not work.
• Do not move the appliance while in use.
• Do not use the appliance if it is tipped up and do not turn
it over.
• Do not turn the appliance over while it is in use or
connected to the mains.
• Disconnect the appliance from the mains when not in use
and before undertaking any cleaning task.
• Store this appliance out of reach of children and/or
persons with physical, sensory or reduced mental or lack
of experience and knowledge.
• Keep the appliance in a dry, dust-free place, out of direct
sunlight.
• Make sure that dust, dirt or other foreign objects do not
block the fan grill on the appliance.
• Keep the appliance in good condition. Check that the
moving parts are not misaligned or jammed and make
sure there are no broken parts or anomalies that may
prevent the appliance from operating correctly.
• Never leave the appliance connected and unattended if
is not in use. This saves energy and prolongs the life of
the appliance.
• Do not use the appliance to dry pets or animals.
• Do not use the appliance to dry textiles of any kind.
INSTALLATION
• Be sure to remove all packaging material from inside the
appliance.
• Ensure that the fan is switched off from the supply mains
before start any installation or assembly operation.
• Do not remove the support base of the appliance.
• Ensure that the appliance is level with respect to the floor.
• Do not cover or obstruct the sides of the appliance
and leave a minimum space of 40cm front other walls,
ceiling...
• The plug must be easily accessible so it can be
disconnected in an emergency.
• The appliance should be used with its base fitted.