Descargar Imprimir esta página

HIKVISION DS-2XS3Q47G1-LDWH/C18S40 Guia De Inicio Rapido página 25

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
(1) cet appareil ne doit pas causer d'interférences, et
(2) cet appareil doit accepter toute interférence reçue,
notamment les interférences susceptibles d'occasionner un
fonctionnement indésirable de l'appareil.
This equipment complies with IC RSS-102 radiation exposure limits
set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between
the radiator & your body.
Cet appareil est conforme aux limites d'exposition au
rayonnement IC RSS-102 établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé à une distance
minimale de 20 cm entre la source du rayonnement et votre corps.
KC
B급 기기: 이 기기는 가정용(B급) 전자파적합기기로써
주로 가정에서 사용하는 것을 목적으로 하며, 모든
지역에서 사용할 수 있습니다.
Safety Information
Please read all the safety information carefully before using.
 In the use of the product, you must be in strict compliance with
the electrical safety regulations of the nation and region.
 Provide a surge suppressor at the inlet opening of the device
under special conditions such as the mountain top, iron tower,
and forest.
 For the device powered on and off only by power plug and
socket-outlet, the socket-outlet shall be installed near the
device and easily accessible.
 Do not touch the bare components (such as the metal contacts
of the inlets) and wait for at least 5 minutes, since electricity
may still exist after the device is powered off.
 Do not ingest battery. Chemical Burn Hazard!
 This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
 Keep new and used batteries away from children.
 If the battery compartment does not close securely, stop using
the product and keep it away from children.
 If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.
 CAUTION: Risk of explosion if the battery is replaced by an
incorrect type.
 Improper replacement of the battery with an incorrect type
may defeat a safeguard (for example, in the case of some
lithium battery types).
 Do not dispose of the battery into fire or a hot oven, or
mechanically crush or cut the battery, which may result in an
explosion.
 Do not leave the battery in an extremely high temperature
surrounding environment, which may result in an explosion or
the leakage of flammable liquid or gas.
 Do not subject the battery to extremely low air pressure, which
may result in an explosion or the leakage of flammable liquid
or gas.
 Dispose of used batteries according to the instructions.
Conformité à la réglementation et consignes de sécurité
 + identifies the positive terminals of the device which is used
with, or generates direct current, and - identifies the negative
terminal(s) of the device which is used with, or generates
direct current.
 No naked flame sources, such as lighted candles, should be
placed on the device.
 If the serial port of the device is used for debugging only, it is
reserved only for professionals or technical support for device
maintenance.
 For the device with sticker
pay attention to the following cautions:
CAUTION: Hot parts! Do not touch. Burned fingers when
handling the parts. Wait one-half hour after switching off
before handling the parts.
 This equipment is not suitable for use in locations where
children are likely to be present.
 If the device installation is needed,
1. Install the device according to the instructions in Quick Start
Guide.
2. To prevent injury, this device must be securely attached to
the installation surface in accordance with the installation
instructions.
 Never place the device in an unstable location. The device may
fall, causing serious personal injury or death.
 If the device supports wall mounting or ceiling mounting, the
mounting surface shall be able to withstand the additional
force of three times the weight of the device but not less than
50 N. The device and its associated mounting means shall
remain secure during the installation. After the installation, the
device, including any associated mounting plate, shall not be
damaged.
 CAUTION: If the bracket is designed for a specific device model
of our company, use the bracket with the corresponding device
only. Use with other devices may result in instability and cause
injury.
 CAUTION: If the device needs to be installed with a specific
bracket of our company, use the corresponding bracket only.
Use others (such as carts, stands, and carriers) may result in
instability and cause injury. Refer to the device datasheet for
bracket model details.
 If the device needs to be wired by yourself, select the
corresponding wire to supply power according to the electric
parameters labeled on the device. Strip off wire with a
standard wire stripper at corresponding position. To avoid
serious consequences, the length of stripped wire shall be
appropriate, and conductors shall not be exposed.
 Make sure that the power has been disconnected before you
wire, install, or disassemble the device.
 If smoke, odor, or noise arises from the device, immediately
turn off the power, unplug the power cable, and contact the
service center.
24
or
,
Français

Publicidad

loading

Este manual también es adecuado para:

Ds-2xs3q47g1-ldw/c18s40