PNI SafeHome PTY6526 Manual Del Usuario página 5

1 Latch bolt
2 Dead bolt
The cutting template
- Carefully refer to the template in the box before marking and
drilling the door.
- If there are deviations after drilling the holes, install the latch and
the handles on the door and correct the holes until the desired
position is obtained.
- 1 - screw holes; 2 - handle hole; 3 – Keyhole
Installation:
1. Dig holes according to hte drawings.
2. Place the mortise in the door;
3. Fix the mortise with the two screws;
4. Install the connecting rod on the lock;
5. Insert the square pole into the mortise;
6. Place the spring into the rear handle;
7. Place the 2 handles on the door and tighten the 2 long screws;
8. Install the alkaline batteries and fix the cover to the batteries as well;
9. The counter plate is mounted in the counterplate box
3 Stopblock
4 Plate
5