Kärcher KHB 6 Manual De Instrucciones página 12

Do not operate the device without a fine filter or with a
damaged fine filter.
Check the fine filter for damage before installation and
replace a damaged fine filter immediately.
2. Clean the fine filter:
a Unscrew the coupling on the water spigot.
b Remove the fine filter.
c Clean the fine filter under running water against
its normal flow direction.
Illustration H
3. Install the fine filter in the reverse order.
Troubleshooting guide
DANGER
Touching live parts
Electric shock
Switch off the device and remove the battery pack be-
fore performing any work on the device.
Have repair work and work on electrical components
carried out by the authorised customer service only.
You can remedy minor faults using the following over-
view.
If in any doubt, please contact your authorised Custom-
er Service.
Device not running
The battery pack is not sitting properly in the device
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
The charging state of the battery pack is too low
1. Charge the battery pack.
The battery pack is overheated
1. Remove the battery pack from the device and allow
it to cool down.
2. Do not the place the device and battery pack in di-
rect sunlight.
The battery pack or the charger are defective
1. Replace the battery pack or charger.
Device switches off automatically
Overheating of the device or battery pack
1. Let the device or the battery pack cool down.
Device not building up pressure
The nozzle is dirty
1. Use a needle to remove dirt from the nozzle hole.
2. Rinse the nozzle from the front with water.
The water supply is too low
1. Open the water tap fully.
2. Check the water inlet for an adequate flow rate.
3. Check the fine filter in the water connection.
Device leaking
1. The device leaks a small amount for technical rea-
sons. If the leak is severe, request authorised Cus-
tomer Service.
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
12
Declaration of Conformity
EU Declaration of Conformity
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
Product: Pressure cleaner (battery powered)
Type: 1.328-xxx
Currently applicable EU Directives
2014/35/EU
2014/30/EU
2011/65/EU
2000/14/EC
Harmonised standards used
EN 60335-1
EN 60335-2-54
EN 62233: 2008
EN 55014-1: 2017
EN 55014-2: 2015
EN IEC 63000: 2018
Applied conformity evaluation method
2000/14/EG: Annex V
Sound power level dB(A)
KHB 5
Measured: 86
Guaranteed: 89
KHB 6
Measured: 81
Guaranteed: 84
KHB 4-18
Measured: 82
Guaranteed: 84
The signatories act on behalf of and with the authority of
the company management.
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2021/03/01
Declaration of Conformity (UK)
We hereby declare that the product described below
complies with the relevant provisions of the following
UK Regulations, both in its basic design and construc-
tion as well as in the version put into circulation by us.
This declaration shall cease to be valid if the product is
modified without our prior approval.
Product: Pressure cleaner (battery powered)
Type: 1.328-xxx
Currently applicable UK Regulations
S.I. 2016/1101 (as amended)
S.I. 2016/1091 (as amended)
English