Publicidad
Idiomas disponibles
Idiomas disponibles
Ref. 5441 - 5451 - 5421 R. F. Transmitter for 1 system (Handheld – Wall)
"
"
"
"
"
"
Using the transmitters Ref. 5441, Ref. 5451 and Ref. 5421 it is possible to control a single system. The
system is monitored throughout the various phases of the movement and its status is communicated to the
user by means of the LD LED.
When used for the first time (or if no system is assigned to the transmitter) LED LD flashes twice when
any button is pressed (except "
The factory settings are as follows:
buttons "
button "
button "
the LD LED signals the status of the system or the information regarding the setting
procedures (see "LED signals")
Note: Using the transmitters Ref. 5441, Ref. 5451 and Ref. 5421 up to 4 systems can be controlled
simultaneously. In this case the assigning procedure must be performed separately on each different system.
The commands given will be performed simultaneously by all the assigned systems.
A system can be associated with the transmitter by means of the assigning procedure.
1. Press button "
2. Press the R. F. button of the system you wish to associate until the respective LED comes on
(see attachments "F" - "G" - "H" and refer to the relative technical manual if necessary)
The system transmits its own identification code to the transmitter (5 quick flashes of the LD LED
confirm that the assigning procedure has been successful).
8
LD
"
"
5441
"
"
"
"
●
").
▲
►
▼
" – "
" and "
■
" stops the system
●
"activates the setting procedure
●
" until LED LD flashes 5 times followed by 3 quick flashes
"
"
"
"
"
"
"
"
"
"
"
"
LD
5421
Operating
◄
" – "
" activate the system
Assigning a system
2
Z244 rC
LD
"
"
5451
"
"
"
"
"
"
Publicidad
