Publicidad
Idiomas disponibles
Idiomas disponibles
Recommended AV Connections
These diagrams show our recommendations for how to connect the TV unit to your various equipment.
For other connections, consult the instructions of each equipment, and the specifications (p. 61).
For additional assistance, please visit our website at : www.panasonic.com
INPUT3
■
To watch camcorder
images
Camcorder
S-Video
Camcorder
VCR/S-Video
VCR
DVD Player
Cable TV
or
•
For receiving digital broadcasting of cable TV,
connect Cable TV directly to "ANTENNA Cable
In" terminal.
•
CableCARD™
Insert a card to watch cable channels serving digital
high-definition video.
Consult the cable company for information.
•
IR Blaster (p. 56)
You can operate the VCR from the TV remote
control or reserve recording with TV Guide.
Install the light emitting area of the IR Blaster near
the signal-receiving area for the remote control on
the VCR.
Note
•
To make schedule recording using TV Guide with IR
blaster, you have to select in your VCR Line-1 (L-1)
and set your VCR in OFF condition. (Refer to the
Operating Instruction manual of VCR)
Mount with
Top shelf of TV stand
two-sided tape
VCR
Signal-emitting
area
Signal-emitting area
of remote control
Signal-receiving area of
VCR
remote control
46
www.panasonic.ca
AC Cord
Back of the unit
(Connect after all the other
connections.)
G-LINK
■
To watch
cable TV
IR Blaster
(Supplied)
■
CableCARD™
PC
RGB PC cable
Conversion adapter (if necessary)
Computer
Audio cable
• Digital audio amplifier
• Theater system
■
To watch DVDs
DVD Player
Set Top Box
(VCR Only)
■
To record TV
shows
DVD Recorder /
VCR
RF OUT
or
RF IN
■
Recommended HDMI Connections
(p. 36-37)
F-Type
or
Antenna
Adapter
S-Video signals have priority
Caution
•
For Antenna connection via VCR, please refer to the Operating Instructions for your VCR.
•
If you use both IR Blaster and "HDAVI Control" (P. 34) for the same Panasonic DIGA (with VCR type), please set
"Power off link" (under "Other adjust" of "Setup" menu ) to "No" (P. 34), to avoid failure for your recording.
■
To watch digital video image
or
or
HDMI-DVI
conversion
cable
Audio cable
DVD Player or Set Top Box
(HDMI compatible machines only)
Note
•
The picture and audio input signals
connected to a terminal specified in "Prog-
out stop" (p. 32) cannot be output from
"OUTPUT" terminals. However, audio
output can be obtained from the optical
Digital Audio Out terminal.
•
To prevent howling and image oscillation, set
the "Prog-out-stop" setting when connecting
VCR with loop-connection. (p. 32)
•
When a device (STB, DVD, etc.) is
connected to the HDMI or COMPONENT
terminals, only audio signals will be
output. No video signals will be output.
■
To listen to the TV through
speakers
Amplifier
•
Turn Off the TV speakers.
(p. 32 "Speakers")
HDMI
cable
47
Publicidad
