Publicidad
Idiomas disponibles
Idiomas disponibles
2. The circuit breaker switches of the oven shall be placed
so that end user can reach them when the oven is installed.
3. The power supply cord shall not contact the hot parts of
the appliance.
4. If the power supply cord is damaged, this cord shall be
replaced by the manufacturer or its service agent or an
equally qualified personnel to prevent a hazardous
situation.
5. Never wash the product by spraying or pouring water
on it! There is a risk of electrocution.
6. WARNING: To avoid electric shock, ensure that the
device circuit is open before changing the lamp.
7. WARNING: Cut off all supply circuit connections
before accessing the terminals.
8. WARNING: If the surface is cracked, turn off the
appliance to avoid risk of electric shock.
9. Do not use cut or damaged cords or extension cords
other than the original cord.
10. The rear surface of the oven also heats up when
the oven is operated. Electrical connections shall not
touch the rear surface, otherwise the connections
may be damaged.
11. Do not tighten the connecting cables to the oven
door and do not run them over hot surfaces. If the cord
melts, this may cause the oven to short circuit and even a
fire.
12. If the power supply cable is damaged, it must be
replaced by its manufacturer or authorized technical service
or any other personnel qualified at the same level, in order
to avoid any dangerous situation.
9
V.1
Publicidad
