Silverline 361429 Traducción Del Manual Original página 8

GB
Troubleshooting
Problem
Tool operating slowly
Tool seized
Tool will not stop after
trigger is fully released
If the above troubleshooting solutions fail, contact your dealer or an authorised
Silverline service centre.
8
Possible Cause Solution
Pressure incorrect Set the correct air
pressure according to the
specification
Dirt within the mechanism Pour oil into air inlet
as per maintenance
instructions
Air blockage Operate tool in short
bursts to clear blockage
Air leak Check all fittings and hose
for air leaks and correct
issue by re-tightening,
using PTFE tape or
replacing
Blockage in gauze Remove Quick Connector
mesh filter (5 / 6) and clean mesh
filter
Dirt or rust in mechanism Try 'Tool operating slowly'
solutions
Dirt or rust in mechanism Tap tool gently with a
soft mallet
Dirt or rust in mechanism Free mechanism by
rotating drive manually
when disconnected from
air line
Throttle valve O-ring or Have the tool repaired at
valve seat damaged an authorised Silverline
service centre