Publicidad
saluran pertama kemudian tekan lama tombol
navigasi kanan untuk masuk ke mode pasangan)
6. Tekan tombol daya pada Interview PRO sekali
untuk masuk ke mode pasangan (LED tombol
daya akan berkedip biru)
7. Saat berhasil dipasangkan, LED tombol daya
Interview PRO akan berubah menjadi hijau solid
(ini akan berubah menjadi kuning saat tingkat
baterai rendah dan merah saat kritis)
8. Tekan tombol 'REC' untuk memulai dan
menghentikan perekaman di papan
9. Tekan tombol 'Mute' untuk menghentikan sinyal
Interview PRO dari dikirim ke penerima nirkabel
(perekaman di papan akan tetap berlanjut ketika
'Mute' diaktifkan)
10. Lihat panduan pengguna untuk mempelajari
tentang kemampuan timecode dan pengaturan
lanjutan serta fitur lainnya
Unduh dan instal RØDE Central untuk mengekspor
rekaman di papan, mengelola pengaturan, dan
menjalankan pembaruan firmware. Pastikan untuk
menggunakan kabel USB-C SuperSpeed yang
disertakan untuk hasil terbaik rode.com/apps/rode-
central
North America
The Interview Pro must not be co-located or
operated in conjunction with any other antenna
or transmitter.
The device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one of more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an outlet on a
Publicidad
