cecotec ENERGY SILENCE AERO 5285 CONNECTED Manual De Instrucciones página 44

ENGLISH
3. PRODUCT ASSEMBLY
General assembly instructions
- If you wish to install the fan with a hook, the minimum weight capacity of the hook must
be 100 kg.
- To prevent personal injury and damage, make sure that the location where the appliance is
going to be installed allows a 2.3-metre clearance from the blades to the floor and a 76-cm
clearance from the blades to any wall or object.
- Make sure that the building structure can hold the full weight of the fan.
Assembly according to the type of ceiling:
- Wooden ceiling. Fig. 3
- Concrete ceiling: Drill a ø 8 mm hole and insert the screw. Align the bracket with the hole
and tighten it with the nut. Fig. 4
To assemble this ceiling fan, follow the steps below:
1. Place the control receiver on the left engine coupling and connect the wiring as shown in
the figures 5 and 6.
Tip: To save time, place the washers on the blade screws before installing the blades.
2. Align the holes in the blades with the holes in the motor. Be sure to securely fasten the
screws when installing each blade. Tighten them permanently only after all blades have
been installed. Fig. 7
Note: Be sure to tighten the blade screws a second time.
4. OPERATION
Remote control. Fig. 8
1. Power button
2. Speed control
3. Winter function
4. Summer function
5. Natural Breeze
6. Natural Breeze shut-off
7. Timer controls
- Use the speed buttons to select the air power level.
- Press the power button to turn the appliance off.
- Use the timer buttons to select the fan operating time. The fan will turn off once the
selected time has elapsed.
- The remote control requires 2 x 1.5 V-3 AAA batteries.
44
ENERGYSILENCE AERO 5285 CONNECTED | ENERGYSILENCE AERO 5500 AQUA CONNECTED