Publicidad
Idiomas disponibles
Idiomas disponibles
Disposal of the packaging
GB
MT
Operating components
Oil suction pump
On/Off switch
2
3
Positive connection terminal (red)
Minus connection terminal (black)
4
Connection for discharge hose
5
Connection for suction hose
6
Suction hose (Ø 6 mm)
7
Discharge hose (Ø 12 mm)
8
9
Hose clamps
Handling and operation
Preparing the oil suction pump
26
The packaging protects the device from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces the amount of waste generated. Dispose of packaging material
that is no longer needed as per the regionally established regulations.
In this chapter you receive important information for the handling and operation
of the device.
♦
Remove the protective caps from the hose connections
♦
Roll out the suction hose (Ø 6 mm)
and bend them straight.
♦
Press the suction hose (Ø 6 mm)
hose
.
6
♦
Press the discharge hose (Ø 12 mm)
discharge hose
5
♦
Thereby, bear in mind the direction of fl ow (
on the type plate of the oil suction pump
♦
Secure both hoses with the supplied hose clamps
TAKE NOTE
►
Ensure that the hoses are not kinked or bent, otherwise the hoses and the
pump could be damaged.
and the discharge hose (Ø 12 mm)
7
onto the connection for the suction
7
onto the connection for the
8
.
+
.
6
5
) given
Pump direction
.
.
9
UOP 12 A1
8
Publicidad
