SOMFY animeo Motor Controller 4DC KNX WM AC Guia De Instalacion página 18

EN
CHARACTERISTICS
Supply voltage
Max. rated current
Stand-by current (IEC 62301)
Stand-by power (IEC 62301)
Supply voltage KNX bus
Rated current consumption KNX
Supply voltage group control input
Supply voltage local push buttons
Max. motor current consumption
External overcurrent protection
Outputs
Without contact gap
Terminals
Terminals KNX
Running time per output
Operating temperature
Relative humidity
Material of housing
Housing dimensions
Weight
Protection class
Degree of protection
Overvoltage category
Pollution degree
Conformity
CABLES
Connection to ... Cable
Motors Min.: 3 x 0.28 mm²/22 AWG
Max.: 3 x 2.5 mm²/13 AWG
Switch Min.: 3 x 0.28 mm²/22 AWG
Max.: 3 x 2.5 mm²/13 AWG
Group control Min.: 3 x 0.28 mm²/22 AWG
Max.: 3 x 1.5 mm²/15 AWG
KNX bus 2 x 0.5 mm²/20 AWG
220 - 230 V AC Min.: 3 x 1.5 mm²/15 AWG
Max.:3 x 2.5 mm²/13 AWG
We care about our environment. Do not dispose of the appliance with usual household waste. Give it to an ap-
proved collection point for recycling.
18/48 -
animeo Motor Controller 4DC KNX WM AC Ref. 5172914A
220 - 230 V AC / 50/60 Hz ~
0.6 A
17 mA@230 V AC
0,49 W@230 V AC
KNX voltage 21...30 V DC, SELV
As per KNX guidelines, 10 mA
SELV, 16 V DC ⎓
SELV, 16 V DC ⎓
4 x 0.6 A@24 V DC; max. 1 motor per output
16 A fuse required
Short circuit protected
Semiconductor switching device: ɛ
Spring connectors
KNX bus terminal (black/red)
Max. 5 minutes
- 5° C ... 50° C
Max. 85 %
PC-ABS
180 x 255 x 61 mm
765 g
II
IP 20
III
2
www.somfy.com/ce
Twisted pair
Recommended
Recommended
Required, following KNX
topology guidelines
Max. length Stripping length
20 m/66 ft 9...10 mm/0.35...0.39"
100 m/330 ft 9...10 mm/0.35...0.39"
50 m/165 ft 9...10 mm/0.35...0.39"
9...10 mm/0.35...0.39"
9...10 mm/0.35...0.39"