Publicidad
Idiomas disponibles
Idiomas disponibles
EN
INTRODUCTION
Thank you for the purchase of our quality product. Used carefully and in accordance with the instructions set
out below. Please read and keep these instructions for future reference.
PARTS
(Photo shown may vary from the product.)
1. Removable Shelves.
2. Leveling Legs (4)
3. Water tray.
4. Glass See-though Door (door frame will vary
per model purchased).
5. Interior light.
6. Switch for interior light.
7. Adjustable Temperature Control.
8. LED temperature display.
12 | www.garsaco.com
INSTALLING
Unpacking your Wine cellar:
1. Remove all packaging material. This includes the
base and all adhesive tape holding the wine cellar
accessories inside and outside.
2 Inspect and remove any remains of packing,
tape or printed materials before powering on the
wine cellar.
Leveling your Wine cellar:
1. Your wine cellar has 4 leveling legs. After properly
placing your wine cellar in its final position, you can
level your wine cellar.
2. Leveling legs can be adjusted by turning them
clockwise to raise your wine cellar or by turning
them counterclockwise to lower your wine cellar.
Proper Air Circulation
1. To assure your wine cellar works at the maximum
efficiency it was designed for, you should install it in
a location where there is proper air circulation and
electrical connections.
The following are recommended clearances around
the wine cellar.
Sides .............2 inches. (50mm).
Top .................2 inches. (50mm).
Back ...............2 inches. (50mm).
3. Do not over fill your wine cellar for proper internal
air circulation.
4. NOTE: allow enough space in the front of the unit
to open the door to 120°.
Electrical Requirement:
1. Make sure there is a suitable power Outlet (220-
240V~ 50/60Hz) with proper earthing to power the
wine cellar.
2. Avoid the use of two-pin adapters or cutting off
the third earthing pin in order to accommodate a
two plug outlet. This is a dangerous practice since
it provides no effective grounding for the wine cellar
and may result in shock hazard.
Publicidad
