Canopy and carrying handle
of the baby bath
The carrycot is equipped with a canopy. The frame also
serves as a carrying handle (it is a handle for carrying
the carrycot alone, not the entire stroller). Do not carry
the carrycot with your baby under any circumstances.
Important Notice. Before lifting the carrycot, set the
handle in the canopy to an upright position (perpendic-
ular to the ground). The canopy is adjustable in posi-
tion. To adjust the canopy to the desired position, press
the round plastic buttons attached to it (Fig. 40, 41).
Assembly and disassembly
of the baby car seat with adapter
To install the infant carrier from group O+ on the stroll-
er frame, the adapters must fi rst be mounted. Insert the
adapters one after the other into the right or left pock-
et until you hear a clear click (Fig. 42, 43). Then place
the infant carrier on the adapters. If you hear a clear
click, the infant carrier is seated correctly (Fig. 44). To
remove the infant carrier, press the two buttons under
the handle of the infant carrier (Fig. 45) and lift it. To
remove the adapters, operate the levers on the inside
of the adapters and pull them out (Fig. 46).
Adjusting the suspension hardness
The stroller is equipped with a suspension hardness
adjustment. To set the suspension to soft mode, move
the lever under the brake rod down (Fig. 47). If you
want to set the mode to hard, move the lever up (Fig.
48).
Attention! To adjust the suspension hardness, all at-
tachments must fi rst be removed. In addition, the shop-
ping basket must be empty.
For soft suspension (lever in lower position, Fig. 48),
it is important to operate the lever exclusively from
above. Caution: Danger of jamming!
Folding the frame
To fold the frame, press the red button on the right side
of the guide rail (Fig. 49) and then pull up the plastic
levers on both sides of the stroller (Fig. 50). Lift the
bottom of the basket when folding the stroller (Fig. 51).
This makes folding easier.
41
43
45
47
49
42
44
46
48
50