Hilti TE 50 Manual De Instrucciones página 19

2.2 Chuck
TE‑Y chuck (SDS-max)
2.3 Switches
Speed control switch for smooth starting
Function selector switch:
Hammer drilling
en
Drilling without hammering
Chiseling
Chisel position adjustment (12 positions)
2.4 Grips
Vibration-absorbing, pivotable side handle
Vibration-absorbing grip
2.5 Protective device
Mechanical slip clutch
Electronic restart interlock to prevent the power tool starting unintentionally after an interruption in the electric supply
(see section 9 "Troubleshooting").
2.6 Lubrication
Oil lubrication
2.7 Active vibration reduction (only TE 50‑AVR)
The power tool is equipped with an AVR active vibration reduction system which reduces vibration significantly
compared to power tools without active vibration reduction.
2.8 TPS theft protection system (optional)
The power tool may be equipped with the TPS theft protection system as an option. If the power tool is equipped with
this feature, it can be unlocked and made ready for operation only through use of the corresponding TPS key.
2.9 LED indicators
Service indicator LED (see section "Care and maintenance")
Theft protection system indicator (optional) (see section "Operation")
2.10 Items supplied as standard
1 Power tool with side handle
1 Hilti toolbox
1 Operating instructions
1 Depth gauge
1 Cleaning cloth
1 Grease
2.11 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section. The
power tool may otherwise loose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 100V
Mains voltage 110-120 V
Mains voltage 220-240 V
16
1.5 mm² 2 mm²
30 m
20 m 30 m
30 m
2.5 mm² 3.5 mm²
50 m
40 m
75 m