Publicidad
Idiomas disponibles
Idiomas disponibles
All other:
Weight kg
45-52
Weight lbs
99-115 116-130 131-150 151-170 171-194 195-220 221-256 257-287 288-325
Category
1
REQUIRED COMPONENTS
The foot can be attached to the socket with direct lamination or by using
one of the following options:
Lamination Connector Kit - see assembly instructions below.
Alignment Adapters - refer to Instructions for relevant alignment adapter.
ASSEMBLY INSTRUCTIONS
CAUTION: Epoxy can cause allergic reactions when in direct contact with
body.
CAUTION: There may be a cutting hazard due to sharp edges or splinters
on the device.
Nike Soles
The device can be fitted with a Nike spike pad or Nike sole. Refer to
instructions for relevant sole/pad for assembly instructions.
Lamination connector
The lamination connector must be laminated directly onto the posterior
wall of the socket.
WARNING: Before starting, make sure to orient the lamination
connector the correct way. The shoulders of the inserts (marked with
arrow) should be oriented towards the socket (Figure 1 & 2).
1. Put the lamination connector in the middle third of the socket to
make height adjustment easier.
2. Make sure the socket surface is flat. A flat surface below the
lamination connector distributes the load from the foot evenly onto
the socket.
3. Use a friction pad between the lamination connecter and the foot.
4. Apply thread locker and torque bolts as shown in the table below.
Device
Flex-Foot Cheetah x
Cheetah Xtend
Cheetah Xtreme
Cheetah Xcel
Cheetah Junior
Cheetah Xpanse
Weight limit
Bolt size
Torque
values [Nm]
53-59
60-68
69-77
2
3
4
Lamination connector kits
Lamination connector
kit (FSX50009)
x
x
x
x
147 kg
3/8"
45 Nm
78-88
89-100 101-116 117-130 131-147
5
6
7
Lamination connector
kit, pediatric (CHX50001)
x
55 kg
5/16"
28 Nm
8
9
5
Publicidad
