Parkside PDSS 13 D4 Instrucciones De Utilización Y De Seguridad página 14

DANGER! Keep hands and other
parts of the body away from rotating
parts to avoid risk of injury.
Operation
Setup and use
NOTE: Always operate the product with compressed
air that is clean, oil-free and moisture-free.
Do not exceed the maximum working pressure of
8 bar at the product.
NOTE: To be able to control the air pressure, the
compressed air supply must be equipped with a
pressure regulator.
Connect the product to a suitable compressed
air source by plugging the quick-connect plug on
the supply hose to the barbed fitting
product. The plug locks into place automatically.
Using the tyre inflator with
pressure gauge
1. Plug the valve connector
2. Press the trigger lever
compressed air.
3. Release the trigger lever
compressed air. Use the pressure gauge
check the pressure.
4. If the pressure is too high (too much air) in the
object you are filling: Press the vent valve
release some air.
5. Press the lever on the valve connector
and unplug the valve connector
6. Disconnect the product from the compressor
after completing work.
Using the accessories
Press the lever on the valve connector
plug in accessory parts
ment into the valve connector
9
14 GB/IE
on the
4
into the valve.
5
to start supplying
6
to stop supplying
6
to
1
to
3
down
5
from the valve.
5
and
5
to or the attach-
10 13
.
5
Using the air blow gun
1. Screw an extension nozzle
matic air blow gun
2. Press the trigger lever
compressed air.
3. Release the trigger lever
compressed air.
4. Disconnect the product from the compressor
after completing work.
NOTE: Detach the hose from the compressor first,
before you remove the supply hose from the product.
This will prevent a situation where the supply hose
whips around uncontrollably.
Maintenance
DANGER OF INJURY!
Always disconnect the product from the com-
pressed air supply before cleaning it.
The product does not require special maintenance.
Cleaning and care
Do not use sharp objects to clean the product.
Do not allow liquids to get inside the product –
this can cause damage to the product.
Clean the product regularly. The best time to
do so is straight after completing work.
Clean the product housing with a dry cloth.
Disposal
The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
onto the pneu-
8
.
7
to start supplying
6
to stop supplying
6