Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
• A stud MUST be located and used for at least one side of the diaper changing station.
• The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore,
MUST be firmly secured in order to support the weight they are intended to support. Contact an architect or
building contractor with any questions.
1.
Locate wood stud where one side of changing station will be mounted to the wall.
2.
Measure up 42" (107 cm) from the floor and mark the wall. This locates the position
for the top attachment hole.
NOTE: Mark on wall MUST be in center of wood stud.
3.
Align hole in top corner of changing station with mark on wall and hold in place.
4.
Using a level, mark the remaining three (3) holes. After marking holes, set changing
station down on ground.
5.
Use a power drill and appropriate bit to drill four (4) holes in the wall.
OPTION 1: For mounting into studs:
Using a 1/8" drill bit, drill the pilot holes. if the finished surface has tile or masonry,
use 1/4" masonry bit through the overlying material, then switch to a 1/8" bit.
OPTION 2: For mounting into hollow wall:
Using a 1/2" drill bit, drill the pilot holes.- Install anchors into the 1/2" holes following
the "using Toggle Anchors" guide below.
6.
Align the holes in the changing station with the drilled holes. Attach the stud side(s)
of the unit using the flat washers, finishing washers, and wood screws into the wood
studs (Figure a.) and the hollow wall side(s) using the flat washers, finishing washers,
and machine screws into the anchors (Figure b). Ensure all screws are tight and install
the 6 provided white caps.
Note: Steel stud or solid wall construction requires additional hardware. Please contact
a professional contractor for assistance in determining suitable hardware.
WARNING
All 4 of these locations MUST be used for safe installation.
The lower holes provide reinforced installation through the
metal brackets.
Using Toggle Anchors (Fig. c.)
1.
Insert metal end of toggle anchor into 1/2" hole.
2.
Use toggle handles to flip the metal toggle upright against the inside wall surface.
3.
Slide zip strip down snugly against wall.
4.
1
2
Fig. c
INSTALLATION INSTRUCTIONS
3
Fig. a
Fig. b
4
1/2024
Publicidad
