Publicidad
Idiomas disponibles
Idiomas disponibles
Recommended Blocking:
If the desired mounting location of the changing station is in a place where no wood
studs can be used for installation, additional blocking is required (fig. d.) Contact an
architect or building contractor to make sure the blocking is adequate and complies
with building codes.
Operation:
Rotate base downward. Place infant on top of the changing surface. Use restraint system
as described below. After child has been changed, remove restraint system and rotate
base back up against the wall.
Use of Restraint System:
Place child so restraint strap is located at abdomen. Rotate top of buckle upward and
insert strap in buckle. Pull strap through buckle until snug against infant. Rotate top of
buckle downward to lock the strap into place. Slide red locking tab over top of buckle
(Fig.e). Reverse steps to loosen strap.
Maintenance and Cleaning:
Check all hardware and components monthly or as required to ensure hardware is
tight and there are no missing or damaged components. Take unit out of service if any
component is missing or damaged and contact customer service to order replacement
parts. Do not substitute parts. For replacement parts, contact customer service at 800-
678-5517. Clean by using a damp cloth with mild soap or mild multi-purpose cleaner.
Do not use any strong chemical cleaners or cleaning agents that may be hazardous to
children.
WARNING
• Child should never be left unattended.
• Avoid serious injury from falling or sliding out. Always use restraint system.
• Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the
total weight limit of 50 pounds (22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable
condition to exist.
INSTALLATION INSTRUCTIONS
Fig. d
Fig. e
1/2024
Publicidad
