Descargar Imprimir esta página

CASO DESIGN HW 770 Advanced Manual Del Usuario página 65

Dispensador de agua instanáneo

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 111
3.1 Before initial use
3.1.1 Preparation of the water lter
1.
Remove the water lter from all packaging.
2.
Wash your hands and clean the water
tank and the lter holder.
3.
Remove the water lter from its packa-
ging and soak it in fresh tap water for 10
minutes.
4.
Rinse the lter for around 10 seconds
under running water.
5.
Insert the lter into the lter holder, en-
suring that it sits rmly. To do this, push
it down with a slight turning movement,
applying some pressure when doing so.
6.
Insert the lter holder into the water tank.
Run water through the lter 2-3 times,
using 1 litre each time, before you drink
the water.
PLEASE NOTE
The lifetime of the water lter lasts about 4-6 weeks of normal use ( ltering of appro-
ximately 150 l water in total).
Despite soaking the lter beforehand, a small residue of black carbon particles may
leak out during use. This is normal and harmless.
Make sure that the bottom of the lter is always in contact with water and never allow
it to dry out. If the lter does dry out, then re-soak it for 10 minutes.
Change the water in the tank every 48 hours at the latest.
Store the water tank and lter in a cool place and keep them out of direct sunlight.
3.1.2 Preparation of the device
1.
Place the device on a hard surface.
2.
Fill the tank with approx. 1 litre of water.
3.
Place a vessel which can hold approx. 700 ml water under the spout.
4.
Start the device with 000 temperature setting until ca. 300 ml water is dispensed.
5.
Set the device to 100°C and dispense 400 ml water.
6.
The device can now be equipped with water lter and lled with fresh water.
7.
The device is ready for use.
3.1.3 Set the water hardness
Press the
-button for a few seconds until the display shows "H1", "H2" or "FIL" under
Clean
"Volume". "H1" stands for soft water. This means that „Descale" will light up in the display
after 60 litres of water were dispensed. „H2" stands for hard water. This means that "Desca-
le" will light up in the display after 25 litres of water were dispensed. Use the "FIL" option
CASO HW 770 Advanced
DE
EN
NL
SV
FR
IT
ES
RU
PT
TR
65

Publicidad

loading

Este manual también es adecuado para:

1889