VH845 ACCESSORIES
The following accessories work great with your humidifier.
These accessories can be purchased at most major retailers.
VapoPads Scent pad can be used to provide soothing menthol (VH7) or
lavender/rosemary (VBR7) vapors. (One complimentary menthol scent
pad included with product)
+
36m*
Use only with
VapoPads Rosemary & Lavender
(VBR7) or Menthol (VH7)
Hygrometer (V70EMEA) enables you to monitor the
humidity level & room temperature to ensure you
maintain a 40-60% humidity rate thus reducing the
survival of flu viruses on surfaces and in the air.
USING VAPOPADS
Your Warm Mist Humidifier can be used with
VapoPads to provide up to 8 hours of soothing vapors. Two free
samples of the menthol VapoPad is included with your humidifier. To
use your unit with scent pads:
• Open Scent Pad Door (See fig. 5 - page 2).
• Open Scent Pad by tearing notch on pad bag. Do not touch pad with
hands. If pad is touched, Do not rub face or eyes as it may cause
irritation (See fig. 6 - page 2).
• Insert Scent Pad with angled end facing towards the product. Up to
two scent pads can be inserted. Close door (See fig. 7 - page 2).
• After 8 hours, discard scent pad. To continue using scent pads,
repeat steps 1-4 (See fig. 8 - page 2).
This Warm Mist (with or without VapoPads) is not
recommended for use by children.
UFI: AD10-80UX-M008-EGSE
reaction. P102 Keep out of reach of children. P302 + P352 IF ON SKIN:
wash with plenty of soap and water. P333 + P313 If skin irritation or
rash occurs: Get medical advice / attention. P501 Dispose of contents
and container to an approved waste disposal plant.
Hazardous Ingredients: Eucalyptus Oil, Cedar leaf oil.
2 menthol VapoPads included.
WARNING: Chokling hazard, keep out of reach of children
and pets. Do not use for babies less than 36 month old, for
+
36m*
more than 16 hours in a 24 hour period and/or not more than
2 pads in a 24 hour period.
CLEANING YOUR HUMIDIFIER
BEFORE CLEANING:
• Turn off and unplug humidifier. NEVER clean the humidifier when it
is running. If the humidifier has recently been in use, wait at least
20-30 minutes for unit to cool before beginning cleaning process
(See fig. 9 - page 2).
6
WARNING:
Pad May present a choking hazard.
Keep out of reach of children and
pets.
H317 May cause an allergic skin
• Remove any accessories and empty Inhalant Cup. Then remove and
empty Water Tank and set aside (See fig. 10 - page 2).
• Pull blue Locking Latch toward front of unit (a) and lift Mist Chimney
up (b) to remove. Remove Water Tray from Base by pulling up from
the Tab (c) and the opening in front of the Latch, then empty Water
Tray (See fig. 11 - page 2).
• Replace Water Tray and Mist Chimney. These must be in place for
cleaning. See Reassembling section (See fig. 12 - page 2).
SCALE REMOVAL:
• Remove Water Tank and slowly pour 0.5 liters of undiluted, distilled
white vinegar into the Reservoir on the Water Tray. DO NOT pour
vinegar over the blue Locking Latch. Only pour into the deep
Reservoir. Note: Pour slowly to give enough time for vinegar to
flow from the Reservoir into the Heating Chamber. The vinegar will
slowly begin to fill the Heating Chamber, located under the Mist
Chimney. Let soak for 20 minutes to loosen scale on the Heating
Element (See fig. 13 - page 2).
Water Tank scale removal steps:
Pour additional vinegar into the Water Tank, replace Tank Cap and
swish to coat inside of Tank. Use a cloth dampened with vinegar to
wipe away any scale on the inside of the Tank and Cap.
• Remove the Mist Chimney by gently sliding blue Locking Latch
towards the front of the unit (a) and lifting Chimney upwards (b)
(See fig. 14 - page 2).
• Remove Heating Element Cover by lifting from the large round
opening and pulling away from the Chimney (See fig. 15 - page 2).
• Wet the bristles of a soft brush with vinegar from the Water Tray and
gently scrub the surface of the Heating Element, Heating Element
Cover, Reservoir, and Heating Chamber to remove mineral deposits
(See fig. 16 - page 2).
DO NOT USE HARD BRUSHES, STEEL WOOL, OR OTHER HARD
ABRASIVES ON THE HEATING ELEMENT. DOING SO WILL DAMAGE
THE HEATING ELEMENT.
DO NOT POUR VINEGAR DIRECTLY ONTO THE HEATING ELEMENT.
NOTE: If scale is still visible on the Heating Element, moisten a paper
towel with vinegar, and wrap it around the Heating Element. Let it
sit for 30 minutes or until scale loosens.
IMPORTANT: Remove paper towel from the Heating Element before
proceeding to the next step.
• Remove Water Tray by gently holding by the Tab and the opening in
front of the Latch, and empty vinegar in sink. Rinse Water Tray and
Heating Element Cover with water until the smell of vinegar is gone
(See fig. 17 - page 2).
• With a soft damp cloth, wipe Heating Element to remove any excess
scale. Snap Heating Element Cover back on the bottom of the Mist
Chimney. It will only fit one way (See fig. 18 - page 2).
• We recommend to use the Protec cleaning fish TWT001EU to prevent
growth of bacteria in the water tank and keep your humidifier clean.
CAUTION: DO NOT RINSE HEATING ELEMENT OR MIST CHIMNEY
IN SINK OR UNDER RUNNING WATER AS WATER CAN GET INTO
INTERNAL PARTS. DOING SO WILL DAMAGE THE HUMIDIFIER
AND VOID THE WARRANTY. ONLY USE A WET CLOTH OR PAPER
TOWEL TO CLEAN THIS PART.
DISINFECTING:
Before starting the disinfecting process, follow Steps 1-4 in Before
Cleaning section.