Publicidad
Idiomas disponibles
Idiomas disponibles
3. Apply the glue in spots. For flexible materials, such as textiles, apply the glue in
zigzag lines.
4. Press the two workpieces to be bonded together immediately after applying
the glue. Hold for approx. 30 seconds. The glued bond is ready after approx.
5 minutes.
Insert a new glue stick
o
totally drawn into the feeder shaft.
During breaks in work, keep the product in standing position so that the product is
standing on its base
NOTE
Some materials may be damaged by exposure to heat. Test on scrap material.
u
Remove any glue residue after it has cooled down with a sharp knife. Bonded
u
joints can be released by heating.
Large areas are difficult to bond. The adhesive will harden before you have
u
extruded the right amount.
˜ Switching off
Switching off the product: Press the on/off button
o
indicator
and the LED work light
[
8 ]
During breaks in work, keep the product in standing position so that the product is
standing on its base
Before storing the product: Allow the product to cool down fully.
m
WARNING!
The hot nozzle
u
42 GB/IE
into the feeder shaft
[
4 ]
.
6 ]
[
.
6 ]
[
can cause damage and/or burns.
1 ]
[
, when the old glue stick is
3 ]
[
. The battery status
7 ]
[
switch off.
9 ]
[
Publicidad
